- Description
- Specifications
Description
DX300-series MB300 Base Station with 115/230 VAC power supply, 2 AA battery sleds, 2 antennas, interconnect cable, and instruction manual.
For more information on the DX300 system options: Click Here
Specifications
General
Frequency Range:
- All, 2400 – 2483.5 MHz
- Low, 2401.92 to 2439.94 MHz
- High, 2443.39 to 2481.41 MHz
Frequency Response:
200 Hz to 3.5 kHz Power
Requirements:
- 100-240VAC, 50-60Hz
- 12-14VDC or six AA batteries (NiMH optional)
Temperature Range:
32-122°F (0-50°C)
Size:
8” x 8” x 3.5” (20.32 x 20.32 x 8.89 cm)
Weight:
2.75 lb with battery (1.25 kg)
# of Beltpacs per Base:
15 can be registered; any 4 can have simultaneous full-duplex communication at one time (in single channel mode)
8-Wire I/O:
RJ45, 600Ω balanced out, high impedance in
Auxiliary Audio:
10-Ckt Phoenix connector, 600Ω balanced out, high impedance in, level adjustable
Headset Connectors:
4-pin mini-DIN Electret microphone: 45 KΩ
Headset Output:
200mW into 32Ω
Top Panel Controls and Indicators:
- Power button
- Left and Right headset controls
- Rotary knobs for headset volume (VOL) adjustment
- Headset SELECT buttons (O=Offense, X=Defense or ALL)
- Headset TALK buttons
- Registration controls
- CLEAR/BAND button
- REGISTER button
- RESET switch (recessed)
- STATUS indicator
- Headset transmit dual-color LEDs, left and right (red/green) – O, X, ALL RECEIVE LEDs (green) – O, X, ALL
Front Panel:
Auxiliary input and output level adjustments
Left Panel:
- 8-wire audio port
- Microphone gain adjustment
- Left headset connector
Right Panel:
- Right headset connector
- Microphone gain adjustment
- 8-wire audio port
- Single/Dual selection switch
- Primary/Secondary selection switch
Rear Panel:
- Auxiliary input and output connectors
- Antenna connectors
Antenna Type:
- External ½ -wave dipole (R-TNC connector)
- RX/TX horizontal/vertical diversity
System Distortion:
<2%
Communication Security:
64-bit encryption dual-slot diversity
Transmitter
Type:
Frequency hopping, spread spectrum
Transmit Power:
100mW burst
Modulation Type:
Gaussian filtered FSK, TDMA
Frequency Stability:
13 ppm
Harmonics/Spurious:
Exceeds FCC and ETSI specifications over temperature
Receiver
Type:
Frequency hopping, spread spectrum
RF Sensitivity:
<–90dBm w 10-3 BER
Frequency Stability:
13 ppm
Distortion:
<2%